Step 1 determine the size of the ledger board to ensure proper strength a ledger board should be made out of the same size lumber that was used to make the deck joists usually 2 inch by 10 inch boards.
Ledger over siding.
Instead cut off a section of siding so ledger can be in complete contact with house.
I want to attach the ledger board directly into the hardiboard siding of the garage with lag screws using washers as spacers for drainage between the ledger and the siding.
After the ledger is installed a second strip of membrane tape is applied over the top of the ledger and about 1 2 in.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
In the long run cutting into the siding and the exterior foam to install the ledger may be more work than installing the additional footings posts and beam needed for a freestanding deck.
This may seem excessively tall but is needed in order for the water resistive barrier wrb and siding to overlap the top.
Attach a deck can be used to mount ledgers on new homes and retrofit decks over siding on existing homes the system is tested by an engineering service the installation is simple and fast lag screws.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
Make sure to install flashing under the siding extending over the ledger the flashing prevents the build up of moisture which causes rotting.
The attach a deck is a simple deck ledger mounting system that stands the ledger off the wall eliminating the need for flashing that s the big benefit but there are other features i like.
Start by making an outline on the siding where you want to position the ledger board.
The wall leg is at least 7 in.
Then cut away the siding.
Mike guertin is a builder and remodeler in east greenwich r i and frequent presenter at jlc live and deckexpo.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
It only weighs 100 pounds it is a ledger board a front plate and eight 2x4 rafters sitting on two 4x4 posts.
The following steps will explain an easy method of removing the lap siding and attaching a ledger board.
Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.
The ledger board is a horizontal framing member usually two by 10 or two by 12 lumber that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding.
