Kia Blind Spot Detection Not Working

If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized k900 kia dealer and have the system checked.

Kia blind spot detection not working.

If the system does not work properly a warning message will appear and the light on the switch will turn off. Remove the foreign matter on the rear bumper. If there is no problem mount the bumper back and perform bsd. When i shut the car off it went off.

If you found any problem in the bsd unit bracket or nut tightening correct the problem or replace the component. When removing the bsd unit be careful not to damage the bracket of bsd. Of course the blind spot alarm does not alarm if you don t signal for a lane change. Disconnect the bsd connector a from the bsd unit.

Again the company chose not to discuss vehicle speed control systems through the manufacturer communications. I find the main blind spot on the niro to be the front pillars especially on a left turn of say 90 degrees. They did however release another notice regarding other advanced safety systems which are just as important. Remove the rear bumper.

And blind spot alarm is sure nice when backing out of parking spot if you are careless and not checking mirrors backup camera or looking. Once i got moving the light remained on until i got to work. If a failure code is displayed or a warning lamp turns on even after performing bsd radar correction 5 times replace the bsd unit. Remove the bsd assembly a after loosening the mounting nuts.

I was driving to work and the warning light came on blind spot radar detector blocked. Be careful when removing the blind spot detection unit. If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized kia dealer and have the system checked. If the system does not work properly a warning message will appear and the light on the switch will turn off.

The bracket may break off from the bumper.