Kenmore In Door Ice Maker Troubleshooting

Please verify whether your house s.

Kenmore in door ice maker troubleshooting.

The kenmore website provides other ways to troubleshoot your. Grip the handle at the bottom of the ice bin and pull it up and out of the ice compartment housing. Check the water supply line for damage pinching or kinks. If the door switch fails the dispenser will not turn on.

In this case you must gently dismantle. To determine if the door switch is defective use a. If the auger is broken replace it. The switch can be checked for continuity with an ohm meter.

The door switch turns off the ice and water dispenser when the refrigerator door is open. Refer to the installation manual for additional help with this step if needed. Check the water lines in the back of the refrigerator to see if there is a visible kink or clog from the hard water that flows from the house line system. Check the fill cup.

Troubleshooting kenmore ice maker not working a faulty inlet valve may cause significant problems by delivering insufficient water. Check your ice maker unit and make sure it s level. Check the auger to determine if it is broken or if it is disconnected from the auger motor. Flush the lines with a solution of one part vinegar and one part water.

A kenmore ice maker that is not filling with water may have a frozen or clogged water line. Remove the ice bin. When the freezer door is opened the freezer door switch does two things it turns on the light in the freezer and turns off the ice maker and dispenser. If your icemaker module does not work correctly it will not eject ice cubes.

Multimeter to test it for continuity. I need to know how to fix an ice maker on a kenmore refrigerator. Open the ice maker compartment door to access the ice maker assembly. Perhaps your ice maker is making ice but it s leaking water in the freezer or leaking onto the floor.

As the auger rotates it pushes the ice toward the dispenser door and down the chute. Check your refrigerator and make sure it s perfectly level. In order for the kenmore elite ice maker to operate properly the water pressure coming from the faucet should be 120 psi at the very least. If someone turned it off i have a different pr.

If the door switch does not have continuity when activated replace it. Make sure it s aligned correctly with the water funnel. I m assuming someone actually turned it on. If the auger is defective it won t be abl e to push the ice out of the dispenser.

If the refrigerator ice maker is not working the door switch might be defective.